Dell XPS 400/Dimension 9150 - Manual (Page 107)

Removing and Installing Parts
107
7 Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into
the computer.
8 Connect your computer and devices to electrical outlets, and turn them on.
9 Enter system setup and restore the settings you recorded in step 1.
10 Properly dispose of the old battery.
Replacing the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1 Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2 Ensure that no tools or extra parts are left inside the computer.
3 Close the cover:
a Pivot the cover down.
b Press down on the right side of the cover until it closes.
c Press down on the left side of the cover until it closes.
d Ensure that both sides of the cover are locked. If not, repeat all of step 3.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
4 Connect your computer and devices to electrical outlets, and turn them on.
battery socket
battery
tab
WD741bk2.book Page 107 Thursday, July 20, 2006 10:44 AM