Display, Display assembly, Removing the display assembly – Dell Studio 1745 (Mid 2009) User Manual
Page 23
Back to Contents Page
Display
Dell Studio™ 1745/1747 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the base cover (see
Removing the Base Cover
).
4.
Disconnect the antenna cables from the Mini-Card(s) (see
Removing the Mini-Card
).
5.
Disconnect the subwoofer assembly cable from the subwoofer assembly cable connector on the system board (see
Removing the Palm Rest
).
6.
Remove the two screws from the computer base.
7.
Remove the center control cover (see
Removing the Center Control Cover
).
8.
Remove the keyboard (see
Removing the Keyboard
).
9.
Remove the media controls board (see
Removing the Media Controls Board
).
10.
Remove the screw that secures the display cable to the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
antenna cables
2
subwoofer assembly cable