Dell Studio XPS 8000 (Late 2009) - Manual (Page 43)

9. Lift the system board up and out.
10. Compare the system board that you just removed with the replacement system board to ensure that they are identical.
Replacing the System Board
1. Follow the procedures in Before You Begin .
2. Gently align the system board into the chassis and slide it towards the back of the computer.
3. Replace the eight screws that secure the system board to the chassis.
4. Connect the cables that you disconnected from the system board (see System Board Components ).
5. Replace the processor (see Replacing the Processor ).
6. Replace the processor fan and the heat sink assembly (see Replacing the Processor Fan and Heat Sink Assembly ).
7. Replace the memory modules (see Replacing the Memory Module(s) ).
8. Replace any PCI and PCI Express cards on the system board, if applicable (see Replacing PCI and PCI Express Cards ).
9. Replace the computer cover (see Replacing the Computer Cover ).
10. Connect your computer and devices to electrical outlets, and turn them on.
11. Flash the system BIOS, as needed.
Back to Contents Page
NOTE: Some components and connectors on the replacement system board may be in different locations compared to the components and
connectors on the existing system board.
NOTE: Jumper settings on the replacement system board is preset at the factory.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: Ensure that the heat sink assembly is correctly seated and secure.
NOTE: For information on flashing the system BIOS, see Flashing the BIOS .