Media card reader, Removing the media card reader – Dell Studio XPS 8000 (Late 2009) User Manual
Page 23
3.
Gently slide the optical drive into the optical drive bay through the front of the computer.
4.
Align the screw holes in the optical drive with the screw holes in the drive panel.
5.
Replace the two screws that secure the optical drive to the drive panel.
6.
Connect the power and data cables to the optical drive (see
System Board Components
).
7.
Replace the front bezel (see
Replacing the Front Bezel
).
8.
Replace the computer cover (see
Replacing the Computer Cover
).
9.
Connect your computer and devices to their electrical outlets, and turn them on.
10.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
11.
Check the System Setup for drive configuration changes (see
System Setup
).
Media Card Reader
Removing the Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the front bezel (see
Removing the Front Bezel
).
4.
Remove the optical drive (see
).
5.
Remove the top cover (see
Removing the Top Cover
).
6.
Remove the two screws that secure the Media Card Reader to the front panel. The screws are located below the Media Card Reader.
7.
Disconnect the Media Card Reader cable from the system board connector (see
System Board Components
).
8.
Slide and remove the Media Card Reader from the computer as shown in the illustration.
1 screw