Dell Latitude E6320 (Early 2011) - Manual (Page 15)

AMT Configuration
After you configure the Intel Management Engine (ME) feature, you must reboot before configuring the Intel AMT for a clean
system boot. The following image shows the Intel AMT configuration menu after a user selects the Intel AMT
Configuration option from the Management Engine BIOS Extension (MEBx) main menu. This feature allows you to
configure an Intel AMT capable computer to support the Intel AMT management features.
NOTE: You need to have a basic understanding of networking and computer technology terms, such as TCP/IP, DHCP,
VLAN, IDE, DNS, subnet mask, default gateway, and domain name. Explaining these terms is beyond the scope of this
document.
To navigate to the Intel AMT Configuration page, perform the following steps:
1. Under the Management Engine BIOS Extension (MEBx) main menu, select Intel AMT Configuration. Press
. The Intel AMT Configuration screen appears.
The quick links displayed on the Intel AMT Configuration screen are:
Manageability Feature Selection
SOL/IDER/KVM
Username and Password
SOL
IDER
Legacy Redirection Mode
KVM
Previous Menu
User Consent
User Opt-in
Opt-in Configurable from remote IT
Previous Menu
Password Policy
Network Setup
Network Name Settings
Host Name
Domain Name
Shared / Dedicated FQDN
Dynamic DNS Update
Periodic Update Interval
TTL
Previous Menu
TCP/IP Settings
Wired LAN IPv4 Configuration
DHCP Mode
IPv4 Address
Subnet Mask Address
Default Gateway Address
Preferred DNS Address
Alternate DNS Address
Previous Menu
Wired LAN IPv6 Configuration
IPv6 Feature Selection
IPv6 Interface ID Type
IPv6 Address
IPv6 Default Router
Preferred DNS IPv6 Address
Alternate DNS IPv6 Address
Previous Menu
Wireless LAN IPv6 Configuration
IPv6 Feature Selection
IPv6 Interface ID Type
Previous Menu
Previous Menu
Previous Menu
Activate Network Access
Unconfigure Network Access
Remote Setup And Configuration
Current Provisioning Mode
Provisioning Record