beautypg.com

Operation, Using your garage door opener, Save these instructions – Chamberlain 1215EM FS2 User Manual

Page 32

background image

OPERATION

Using Your Garage Door Opener

Your Security✚

®

opener and hand-held remote control

have been factory-set to a matching code which changes

with each use, randomly accessing over 100 billion new

codes. Your opener will operate with up to fifty-four

Security✚

®

remote controls and one Security✚

®

Keyless

Entry System. If you purchase a new remote, or if you

wish to deactivate any remote, follow the instructions in

the Programming section.
Activate your opener with any of the following:
The hand-held Remote Control: Hold the push button

down until the door starts to move.

The wall-mounted Door Control: Hold the push button or

bar down until the door starts to move.

The Keyless Entry (See Accessories): If provided with

your garage door opener, it must be programmed

before use. See Programming.

When the opener is activated
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open

position, it will close.

5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.

7. The optional Protector System

®

uses an invisible beam,

which, when broken by an obstruction, causes a closing

door to open and prevents an open door from closing. It

is STRONGLY RECOMMENDED for homeowners with

young children.

The opener lights

will turn on under the following

conditions: when the opener is initially plugged in; when

power is restored after interruption; when the opener is

activated.
They will turn off automatically after 4-1/2 minutes or

provide constant light when the Light feature on the

Multi-Function Door Control is activated. Bulb size is A19.

Bulb power is 100 watts maximum.
Timer to close feature (ONLY available when optional
Protector System

®

is installed):

The door can be

programmed to close the door automatically in 10

seconds, 45 seconds, 2 minutes or 3 minutes.
The Timer to close feature is preset to the off position

from the factory. To activate this feature, press and hold

the Lock button on the Multi-Function Door Control until

the opener light blinks once (about 10 seconds). A single

blink indicates that the timer is reset to 10 seconds.

Repeat the procedure and the light will blink twice,

resetting the timer to 45 seconds. Repeat again for a 2

minute interval, etc., up to a maximum of four blinks and 3

minutes.
To deactivate, set the timer to 3 minutes. Press and hold

the Lock button on the Multi-Function Door Control again

for 10 seconds. The opener light will blink 5 times. This

feature is now deactivated.

32

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of SEVERE INJURY or DEATH:

WARNING

WARNING

WARNING

WARNING

1. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.

NEVER permit children to operate or play with garage door
control push buttons or remote controls.

3. ONLY activate garage door when it can be seen clearly, it

is properly adjusted, and there are no obstructions to door
travel.

4. ALWAYS keep garage door in sight and away from people and

objects until completely closed. NO ONE SHOULD CROSS THE
PATH OF THE MOVING DOOR.

5. NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY OPEN

DOOR.

6. If possible, use emergency release handle to disengage trolley

ONLY when garage door is CLOSED. Use caution when using
this release with the door open. Weak or broken springs or
unbalanced door could result in an open door falling rapidly
and/or unexpectedly and increasing the risk of SEVERE
INJURY or DEATH.

7. NEVER use emergency release handle unless garage doorway

is clear of persons and obstructions.

8. NEVER use handle to pull garage door open or closed. If rope

knot becomes untied, you could fall.

9. If one control (force or travel limits) is adjusted, the other

control may also need adjustment.

10. After ANY adjustments are made, the safety reversal system

MUST be tested.

11. Safety reversal system MUST be tested every month. Garage

door MUST reverse on contact with 1-1/2" high (3.8 cm)
object (or a 2x4 laid fl at) on the fl oor. Failure to adjust the
garage door opener properly increases the risk of SEVERE
INJURY or DEATH.

12. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see

page 3). An improperly balanced door may NOT reverse
when required and could result in SEVERE INJURY or
DEATH.

13. ALL repairs to cables, spring assemblies and other hardware,

ALL of which are under EXTREME tension, MUST be made
by a trained door systems technician.

14. ALWAYS disconnect electric power to garage door opener

BEFORE making ANY repairs or removing covers.

15.

SAVE THESE INSTRUCTIONS.