Chamberlain POWERDRIVE PD610D User Manual
Garage door opener assembly/installation manual, Warning
GARAGE DOOR OPENER
ASSEMBLY/INSTALLATION MANUAL
■
Please read this manual and the enclosed safety materials carefully!
■
Fasten the manual near the garage door after installation.
■
The door WILL NOT CLOSE unless the Protector System
®
is connected
and properly aligned.
■
Periodic checks of the opener are required to ensure safe operation.
■
The model number label is located under the light lens on the front panel of
your opener.
When you see these Safety Symbols and Signal Words on
the following pages, they will alert you to the possibility of
serious injury or death if you do not comply with the
warnings that accompany them. The hazard may come
from something mechanical or from electric shock. Read
the warnings carefully.
When you see this Signal Word on the following pages, it
will alert you to the possibility of damage to your garage
door and/or the garage door opener if you do not comply
with the cautionary statements that accompany it. Read
them carefully.
Mechanical
Electrical
WARNING
WARNING
CAUTION
WARNING
WARNING
WARNING
CAUTION
WARNING
WARNING
WARNING
WARNING
CAUTION
CAUTION
WARNING
WARNING
This garage door opener has been designed and tested to offer safe service provided it is installed, operated,
maintained and tested in strict accordance with the instructions and warnings contained in this manual.
IMPORTANT SAFETY NOTES
PD210D • PD212D
248730
PD610D • PD612D • 7920KD
PD612KLD • 48930D
The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.chamberlain.com
There are two types of garage door openers pictured. Yours may appear slightly different.
Document Outline
- GARAGE DOOR OPENER ASSEMBLY/INSTALLATION MANUAL
- IMPORTANT SAFETY NOTES
- TABLE OF CONTENTS
- PREPARING YOUR GARAGE DOOR
- COMPLETED INSTALLATION
- TOOLS NEEDED
- OPENER CONTENTS
- ASSEMBLY HARDWARE
- INSTALLATION HARDWARE
- ASSEMBLY
- Assemble the Rail
- Remove Fasteners from Top of Motor Unit
- Attach Rail to Motor Unit
- Attach Chain Spreader
- Run Cable Through Cut-Out Window
- Install Idler Pulley
- Attach Cable to Front of Trolley
- Route Chain/Cable Around Rail Assembly and Motor Unit Sprocket
- Attach Chain To Trolley Threaded Shaft
- Attach Nut and Lock Washer to Trolley Threaded Shaft
- Insert Trolley Threaded Shaft into Round Hole in Trolley
- Tighten the Chain
- INSTALLATION-SECTIONAL DOOR
- INSTALLATION-ONE-PIECE DOOR
- ADJUSTMENT
- OPERATION
- HAVING A PROBLEM?
- DIAGNOSTIC CHART
- PROGRAMMING
- REPAIR PARTS
- ACCESSORIES
- NOTES
- WARRANTIES
- HOW TO ORDER REPAIR PARTS
- Spanish