Campbell Hausfeld BUILT TO LAST PW3002 - Manual (Page 6)

8. Install quick connect tip by pulling back on collar and pressing
in tip. Release collar, make sure it completely returns to its
forward position and tip is secure (see Figure 8).
Figure 10a - Trigger locked Figure 10b - Trigger unlocked
Engaged
6
Pre-Operation (Continued)
6. Connect the high pressure hose to the pump outlet (See Figures
2 and 6).
7. Attach the lance to the gun (see Figure 7).
Pressure Washer
Figure 6 – Connect high pressure hose to pump
www.chpower.com
Disengaged
Figure 7– Attach lance to gun
9. Install quick connect tips to tip holder and secure to the
pressure washer handle. See Figure 9.
TRIGGER SAFETY LATCH
In the engaged position, the trigger safety latch prevents the
gun from being triggered accidentally. Push the latch fully up to
engage it (See Figure 10).
Always engage the trigger safety latch when the unit is not in
use.
Figure 8 - Installing Quick Connect Tip
Pull collar back
Figure 9 - Insert spray tips into the rubber tip holder