Campbell Hausfeld BUILT TO LAST PW3002 - Manual (Page 10)

Pressure Washer
10
www.chpower.com
Maintenance
Observe regular maintenance intervals to
ensure maximum performance and life
from the pressure washer. Refer to the
schedule for recommended maintenance.
If you operate the pressure washer in
dusty conditions, perform maintenance
checks more often.
ENGINE OIL CHANGING INSTRUCTIONS
Before
tipping the
engine or equipment to drain oil, drain
fuel from the fuel tank.
NOTE: Change oil while the engine is cool.
1. Disconnect the spark plug wire from
the spark plug.
2. Locate, and if accessible, remove
the engine oil drain plug (if the
engine is equipped with an oil drain
plug, the drain plug is located in at
least one of the locations shown in
Figure 18). If the engine oil drain
plug is not accessible or if the
engine is not equipped with an oil
drain plug, tip the unit on its side
to drain the oil out of the oil fill
tube (See Figure 18).
NOTE: If draining oil from the oil fill tube,
keep the air cleaner side up.
Figure 18 - Oil Drain Locations
3. Drain old oil.
4. Replace the drain plug and set the
unit upright.
5. Refill the unit with new oil of a
recommended type and quantity. Fill
the unit to the proper level shown on
the dipstick (if provided). Otherwise, fill
the unit to the top of the oil filler neck.
1. Oil fill tube
2. Plug on side of
engine base
3. Plug at bottom
of engine
PUMP OIL CHANGING INSTRUCTIONS
Changing or refilling the oil in the
pump requires removal of the pump
from the engine and should not be
required unless oil has leaked out due
to worn or damaged oil seals in the
pump. If oil has leaked out of the
pump, bring the pressure washer to a
certified Campbell Hausfeld service
center for repair.
Service Record
Date Maintenance performed Replacement components required