Dell OptiPlex Gxi - Manual (Page 40)

1-22 Dell OptiPlex GXi Systems Service Manual
Table 1-2. System-Board Jumper Descriptions
Jumper Description Settings
100 * Reserved Do not install jumper.
133 Microprocessor
speed Install jumper if the microprocessor’s
internal speed is 133 MHz; otherwise the
jumper should not be installed.
166 Microprocessor
speed Install jumper if the microprocessor’s
internal speed is 166 MHz; otherwise the
jumper should not be installed.
200 Microprocessor
speed Install jumper if the microprocessor’s
internal speed is 200 MHz; otherwise the
jumper should not be installed.
233 Microprocessor
speed Install jumper if the microprocessor’s
internal speed is 233 MHz; otherwise the
jumper should not be installed.
PSWD Password
enable or
disable
Install to enable the password feature.
BIOS Reserved Do not install jumper.
NICRST NIC enable or
disable Service procedure only — Install jumper,
then boot the computer to clear the NIC set-
tings and reset the base address to 200h;
then remove the jumper to allow configura-
tion changes.
* Not on all systems