Dell OptiPlex Gxi - Manual (Page 30)

1-12 Dell OptiPlex GXi Systems Service Manual
Chapter 4, “Using Integrated Devices,” in the Reference and Installation Guide
provides instructions for connecting the mini tower computer to, and configur-
ing it for, use on an Ethernet network. A Dell OptiPlex GXi Systems
Documentation Update provides instructions for low-profile and midsize
computers.
Floor Stand
The low-profile and midsize computers can be used in a vertical orientation
using an available floor stand. The floor stand is attached to the left side of the
low-profile or midsize computer. The floor stand is permanently attached to the
bottom of the mini tower computer.
C
omputer Service
The following subsections provide service-related information about the
computer.
System Power Supply
The low-profile computers have a 145-W system power supply, whereas the
midsize and mini tower computers have a 200-W system power supply. Both
system power supplies can operate from an AC power source of 115 VAC at
60 Hz or 230 VAC at 50 Hz. The system power supply provides the DC operat-
ing voltages and currents listed in Table 1-1.
NOTE: The power supply produces DC voltages only under its loaded condi-
tion. Therefore, when you measure these voltages, the DC power connectors
must be connected to their corresponding power input connectors on the system
board or drives.
.