Dell PowerEdge 1800 - Manual (Page 18)

16
Installing the Tower-to-Rack and Rack-to-Tower Kits
www
.dell.com | support.dell.com
Installing the Bezel
1 Insert the two tabs on the inside left edge of the bezel into the corresponding slots on the
system front panel, and pivot the bezel inward to its closed position.
NOTE:
When you are closing the right side of the rack-mount system’s bezel, hold the bezel's left
side so that the inside bezel tabs remain properly engaged in the front-panel bezel slots.
2 Use the system key to lock the bezel.
Stabilizing the Tower System
CAUTION:
The tower system has four stabilizer feet on its bottom panel that can be rotated outward to
help properly stabilize the system. Ensure that the four stabilizer feet are rotated outward before you
operate the system. See Figure 1-14.
Figure 1-14. Rotating the Tower System Stabilizer Feet
stabilizer feet (4)
tower system
P2648bk0.book Page 16 Thursday, October 14, 2004 11:18 AM