Dell Inspiron 14 (M4010, Mid 2010) - Manual (Page 21)

12. Make a note of the Mini-Card antenna cables and display cable routing and remove the cables from the routing guides.
13. Hold the display assembly in place and remove the four screws that secure the display assembly to the computer base.
14. Lift and remove the display assembly out of the computer base.
Replacing the Display Assembly
1. Follow the instructions in Before You Begin .
2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3. Route the Mini-Card antenna cables and display cable through the routing guides.
4. Connect the display cable to the connector on the system board, and replace the display cable grounding screw.
5. Connect the antenna cables to the Mini-Card(s) (see Replacing the Mini-Card(s) ).
6. Close the display and turn the computer over.
7. Replace the two screws that secure the display assembly to the computer base.
8. Replace the palm rest (see Replacing the Palm Rest ).
9. Replace the keyboard (see Replacing the Keyboard ).
10. Replace the memory module(s) (see Replacing the Memory Module(s) ).
11. Replace the module cover (see Replacing the Module Cover ).
12. Follow the instructions from step 4 to step 5 in Replacing the Optical Drive .
13. Replace the battery (see Replacing the Battery ).
Display Bezel
1 display cable grounding screw 2 display cable
3 Mini-Card antenna cables 4 screws (4)
5 display assembly
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.