Dell PowerVault 122T SDLT 320 (Autoloader) - Manual (Page 5)

1. From the Home screen or main menu, press + or - button until Information appears on the top line of the LCD screen.
2. Press Enter to access the available options.
3. Press + or - until View Event Log appears on the LCD screen.
The LCD screen also displays the quantity of errors and events currently stored in the event log.
4. Press Enter to access the most recently logged event.
5. Press + or - to display each event in the log.
6. Press Cancel when finished.
Product Revision
This option displays the revision of the hardware that makes up the autoloader.
To use this option, follow these steps:
1. From the Home screen or main menu, press + or - until Information appears on the top line of the LCD screen.
2. Press Enter to access the available options.
3. Press + or - until Product Rev appears on the LCD screen.
The LCD screen displays the revision of the current autoloader hardware.
4. Press Cancel when finished.
Firmware Revision
This option displays the revision of the firmware currently installed in the autoloader.
To use this option, follow these steps:
1. From the Home screen or main menu, press + or - until Information appears on the top line of the LCD screen.
2. Press Enter to access the available options.
3. Press + or - until Firmware Rev appears on the LCD screen.
The LCD screen displays the revision of the firmware currently installed in the autoloader.
4. Press Cancel when finished.
Back to Contents Page
NOTE: The tape drive and autoloader firmware are a single image, but the image may display as three firmware numbers on the front
panel: Drive SCSI Controller , Robotics Controller Firmware , and Robotics SCSI Controller Firmware .
NOTE: After a firmware update, the firmware revision displayed on the LCD may not be updated until the autoloader is power
cycled.
NOTE: The tape drive and autoloader firmware are a single image, but the image may display as three firmware numbers on the front
panel: Drive SCSI Controller , Robotics Controller Firmware , and Robotics SCSI Controller Firmware .
NOTE: After a firmware update, the firmware revision displayed on the LCD may not be updated until the autoloader is power
cycled.