Dell Inspiron 510m - Manual (Page 98)

98
Adding and Replacing Parts
www
.dell.com | support.dell.com
d Pull up on the keyboard connector tab to disconnect the keyboard connector from the
system board.
NOTE:
When you replace the keyboard, ensure that the keyboard tabs are completely in place to avoid
scratching the palm rest.
Internal Card With Bluetooth
®
Wireless Technology
If you ordered an internal card with Bluetooth wireless technology with your computer, the card
is already installed.
CAUTION:
Before working inside your computer, read the safety instructions in the Product
Information Guide.
1 Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2 Save and close any open files, exit any open programs, and then shut down the computer (see
page 32).
3 If the computer is connected to a docking device (docked), undock it. See the documentation
that came with your docking device for instructions.
4 Disconnect the computer from the electrical outlet.
5 Wait 10 to 20 seconds, and then disconnect any attached devices.
6 Remove any installed PC Cards, batteries, and module bay devices.
NOTICE:
Handle components and cards by their edges, and avoid touching pins and contacts. Ground
yourself by touching a metal connector on the back of the computer. Continue to ground yourself
periodically during this procedure.
M2.5 x 5-mm
screws (2)
keyboard tabs
palm rest
D7898bk2.book Page 98 Friday, April 29, 2005 9:39 AM