Dell Studio 1558 (Early 2010) - Manual (Page 48)

Back to Contents Page
USB Connector
Dell Studio™ 1557/1558 Service Manual
Removing the USB Connector
Replacing the USB Connector
Removing the USB Connector
1. Follow the instructions in Before You Begin .
2. Remove the optical drive (see Removing the Optical Drive ).
3. Remove the AC adapter connector (see Removing the AC Adapter Connector ).
4. Remove the screw that secures the USB connector.
5. Remove the USB connector cable from the routing guide.
6. Disconnect the USB connector cable from the system board connector.
7. Lift the USB connector and cable out of the computer base.
Replacing the USB Connector
1. Follow the instructions in Before You Begin .
2. Place the USB connector and cable in the computer base.
3. Replace the screw that secures the USB connector.
4. Route the USB connector cable through the routing guide.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer ) before working
inside the computer.
1 USB connector cable 2 screw
3 USB connector cable routing