Display, Display assembly, Removing the display assembly – Dell Studio 1558 (Early 2010) User Manual
Page 15
Back to Contents Page
Display
Dell Studio™ 1557/1558 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the base cover (see
Removing the Base Cover
).
3.
Disconnect the antenna cables from the Mini-Card(s).
4.
Lift the antenna cables from the securing tabs and release them from the routing channel.
5.
Remove the two screws that secure the display assembly from the bottom of the computer.
6.
Remove the center control cover (see
Removing the Center Control Cover
).
7.
Remove the keyboard (see
Removing the Keyboard
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working
inside the computer.
1
securing tabs
2
antenna cables