Dell Latitude E6500 (Mid 2008) - Manual (Page 39)

2. Grasp the module at the side edges and pull it straight away from the connector. Place the module into anti-static packaging.
DIMM A
1. To remove the DIMM A module, spread away the retaining clips from the side edges of the memory module and lift the free edge of the module so that it
sits at about a 45-degree angle to the system board.
2. Grasp the module at the side edges and pull it straight away from the connector. Place the module into anti-static packaging such as an anti- static bag.
Replacing a Memory Module
DIMM B
1. Ground yourself by touching a bare-metal part in the computer chassis.
2. Remove the memory module from its anti-static packaging and, grasping the module at the side edges, align the slot in the module edge connector with
the key in the socket connector.
3. Gently slide the memory module into the DIMM B connector at a 45-degree angle to the system board until it is fully seated.
4. Push the long edge of the memory module down until retaining clips lock the module in place.
DIMM A
CAUTION: To prevent damage to the memory module connector, do not use tools to spread the memory-module retaining clips.
NOTE: If the memory module is not installed properly, the retaining clips will not hold the module securely and the computer may not boot properly. No
error message indicates this failure.