Dell Dimension L___cx - Manual (Page 42)

Table 12. Exit Screen Options
Clearing NVRAM
To clear NVRAM for all devices and restart the system, perform the following steps:
1. Enter the system setup program .
2. Press the right-arrow key to move to the Advanced menu.
3. Press the down-arrow key to highlight the Boot Configuration submenu, and press .
4. Press the down-arrow key to highlight Reset Config Data. Then change the setting to Yes (see Table 3 ).
5. Press to exit the program and restart the system.
Back to Contents Page
Option Function
Exit Saving
Changes Saves any changes you have made, exits the system setup program, and restarts the system.
Exit Discarding
Changes Discards any changes you have made, exits the system setup program, and restarts the system.
Load Setup
Defaults Discards any changes you have made and reverts all options to their defaults, but does not exit the system setup program.
Load Custom
Defaults Loads any settings saved using the Save Custom Defaults option. Press . Then press the spacebar to select
Yes or No at the confirmation pop-up menu, and press again.
Save Custom
Defaults Saves any changes you have made, but does not exit the system setup program.
Discard Changes Discards any changes you have made and reverts all options to their last saved settings, but does not exit the system
setup program.