Dell 1100 Laser Mono Printer - Manual (Page 49)

Troubleshooting 41
More Troubleshooting
For more information about printing problems, see your HTML User’s Guide .
• You pressed while the printer was receiving data.
• In Manual Duplex mode, the first side of your job has printed. Load the
paper back into the tray with the already-printed side down and the top
of the page toward the front of the tray. Then press to start printing.
For details, see the HTML User’s Guide.
• You print in 600 dpi resolution and your printer does not have enough
memory to print the current job. When the Printing Status window
appears, select one of the following options:
– Click
Cancel. An Internal error sheet prints and the current job
automatically clears. Try simplifying the page layout and removing
unnecessary graphics from your document.
– Click Print. Your printer prints the current job in 300 dpi resolution.
If a memory shortage occurs again, the Printing Status window will
appear again and an Internal error sheet will print. The current job
automatically clears. Try simplifying the page layout and removing
unnecessary graphics from your document.
In Manual Feed mode, there is no paper in the paper tray. Load paper
into the tray and press to start printing.
The toner cartridge is nearly empty. Redistribute the toner to
temporarily extend the life of the toner cartridge. If this does not
improve print quality, install a new toner cartridge. See page 30.
LED Pattern Meaning and Suggested Solution
(Red)
(Orange)
(Orange)
1100-OM_EN.book Page 41 Friday, May 20, 2005 3:14 PM