Dell PowerEdge M710 - Manual (Page 133)

About Your System 133
Memory set to
minimum frequency. The memory frequency
may be intentionally set
lower for power
conservation.
If not an intentional setting,
check any other system
messages for possible causes.
The current memory
configuration may support
only the minimum
frequency.
Ensure that your memory
configuration supports the
higher frequency. See
"System Memory" on
page 171.
Warning! A fatal
error has caused
system reset.
Please check the
event log for
details. Unspecified error. Check the system event log
for information about the
error.
Warning! Following
faulty DIMMs are
disabled: DIMMxx,
DIMMyy. Faulty or improperly
seated memory modules.
See "Troubleshooting Blade
Memory" on page 319.
Warning! No
microcode update
loaded for
processor n. Unsupported processor. Update the BIOS firmware
using the Dell Support
website at support.dell.com.
Warning: The
current memory
configuration is
not validated.
Change it to the
recommended memory
configuration or
press any key to
continue. There is no memory
configuration error, but
the memory configuration
is not recommended by
Dell.
See "System Memory" on
page 171.
Table 1-27. Blade Messages (continued)
Message Causes Corrective Actions