Dell PowerEdge M710 - Manual (Page 130)

130 About Your System
Read fault. Faulty diskette, diskette
drive, or optical drive.
Replace the diskette. Ensure
that the drive cable is
properly connected. See
"Troubleshooting USB
Devices" on page 312 or
"Troubleshooting Hard
Drives" on page 320 for the
appropriate drive(s)
installed in your system.
Remote
Configuration
update attempt
failed. Blade could not
implement Remote
Configuration request.
Retry Remote
Configuration.
Sector not found.
Seek error.
Seek operation
failed. Faulty diskette or hard
drive.
Replace the diskette. If the
problem persists, see
"Troubleshooting Hard
Drives" on page 320 for the
appropriate drive installed in
your system.
Shutdown failure. Shutdown test failure. Ensure that all memory
modules are properly
installed. See
"Troubleshooting Blade
Memory" on page 319. If the
problem persists, see
"Getting Help" on page 361.
Spare bank
enabled. Memory sparing enabled. Information only.
System service
update required. The iDRAC6 Enterprise
Card flash memory may be
corrupted.
Restore the flash memory
using the latest version on
ftp.dell.com or
support.dell.com. See the
iDRAC6 User’s Guide for
instructions on performing a
field replacement of the
flash memory.
Table 1-27. Blade Messages (continued)
Message Causes Corrective Actions