Dell PowerVault MD3260 - Manual (Page 11)

11
Default IPv4 settings for the iSCSI Ports on MD36x0i
array
NOTE: No default gateway is set.
By default, the iSCSI ports on the storage array are set to the following static IPv4 settings:
Table 6. Default iSCSI Port IPv4 Addresses on MD36x0i Storage Arrays
Controller/Port (MD36x0i) IPv4 address Subnet Mask Port #
Controller 0, Port 0 192.168.130.101 255.255.255.0 3260
Controller 0, Port 1 192.168.131.101 255.255.255.0 3260
Controller 1, Port 0 192.168.130.102 255.255.255.0 3260
Controller 1, Port 1 192.168.131.102 255.255.255.0 3260
Default IPv4 settings for the iSCSI Ports on MD32x0i
array
Table 7. Default iSCSI Port IPv4 Addresses on MD32x0i Storage Arrays
Controller/Port IPv4 address Subnet Mask Port #
Controller 0, Port 0 192.168.130.101 255.255.255.0 3260
Controller 0, Port 1 192.168.131.101 255.255.255.0 3260
Controller 0, Port 2 192.168.132.101 255.255.255.0 3260
Controller 0, Port 3 192.168.133.101 255.255.255.0 3260
Controller 1, Port 0 192.168.130.102 255.255.255.0 3260
Controller 1, Port 1 192.168.131.102 255.255.255.0 3260
Controller 1, Port 2 192.168.132.102 255.255.255.0 3260
Controller 1, Port 3 192.168.133.102 255.255.255.0 3260
Supported RAID Controller Firmware and NVSRAM
NOTE: It is advisable to gather support information before performing any
firmware upgrade.
NOTE: Only drivers and firmware released by Dell are supported. For the latest
driver and firmware releases, see the Downloads section at
support.dell.com.