Canon L2000 - Manual (Page 5)

4
II SENDING A DOCUMENT
A. DIRECT SENDING
1. Place documents face up on the feeder
2. Press DIRECT TX (indicator lights up)
3. Enter fax number
4. Press START
B. MEMORY SENDING
1. Place documents face up on the feeder
2. Make sure DIRECT TX is “off”
3. Enter fax number
4. Press START
5. Take note of “ TX / RX ” number
C. ONE-TOUCH / CODED DIAL SENDING
1. Place documents face up on the feeder
2. Press the appropriate one-touch key OR
Press CODED DIAL and a three-digit code
3. Take note of “ TX / RX ” number
C. USING DIRECTORY DIALING
1. Place documents face up on the feeder
2. Press Directory
3. Press a numeric key which contains the 1 st letter of the desired name
4. Press OK
5. Press ▼ to scroll to the desired destination
6. Press OK
7. Press START
N.B. If direct sending is required, activate DIRECT TX before step
No.
2
TO STOP SENDING
A.
During a DIRECT TX sending, press Stop
B./C. During a memory sending, press Stop , then * to confirm
For all of the above methods, press Stop
again to eject the documents,
if any.