Dell Precision 650 User Manual
Page 46
3.
Pull the release lever straight up until the microprocessor is released.
4.
Remove the microprocessor from the socket.
If you are replacing the microprocessor, leave the release lever extended in the release position so that the socket is ready for the new microprocessor
and go to "
If you are removing a second microprocessor and not installing another one,
remove the VRM
and then continue with step 9.
5.
Replace the airflow shroud (for the Dell Precision 650 computer, see "
Microprocessor Airflow Shroud — Dell Precision™ 650 Computer
" or for the Dell
Precision 450 computer, see "
Microprocessor Airflow Shroud — Dell Precision™ 450 Computer
").
6.
Close the computer cover
.
7.
Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
6
lever
NOTICE:
Be careful not to bend any of the pins when you remove the microprocessor from the socket. Bending the pins can permanently damage the
microprocessor.
1
release lever
2
microprocessor
3
socket
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.