Providing power to the cisco unified ip phone – Cisco OL-11953-01 User Manual
Page 4
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Providing Power to the Cisco Unified IP Phone
2-4
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
You can resolve these issues by isolating the voice traffic onto a separate VLAN.
The switch port that the phone is connected to would be configured to have
separate VLANs for carrying:
•
Voice traffic to and from the IP phone (auxiliary VLAN on the Cisco Catalyst
6000 series, for example)
•
Data traffic to and from the PC connected to the switch through the access
port of the IP phone (native VLAN)
Isolating the phones on a separate, auxiliary VLAN increases the quality of the
voice traffic and allows a large number of phones to be added to an existing
network where there are not enough IP addresses for each phone.
For more information, refer to the documentation included with a Cisco switch.
You can also access related documentation at this URL:
Related Topics
•
Understanding the Phone Startup Process, page 2-10
•
Network Configuration Menu, page 4-7
Providing Power to the Cisco Unified IP Phone
The Cisco Unified IP Phone 7961G, 7961G-GE and 7941G, 7941G-GE can be
powered with external power or with Power over Ethernet (PoE). External power
is provided through a separate power supply. PoE is provided by a switch through
the Ethernet cable attached to a phone.
Note
When you install a phone that is powered with external power, connect the power
supply to the phone and to a power outlet before you connect the Ethernet cable
to the phone. When you remove a phone that is powered with external power,
disconnect the Ethernet cable from the phone before you disconnect the power
supply.