beautypg.com

Coleman MONTANA 14'x7' User Manual

Montana, 14’x7’ 1, Connect frame to tent

background image

Connect Frame to Tent

– Locate the pin & ring systems on

either side of the front door and the
corresponding pin & rings on the back
side of tent.

– Insert one end of black frame pole

onto pin & ring system on tent stake
loop on either side of front door. (illus. 3)

– Go to opposite end of pole diagonally

from starting point and gradually apply
pressure to the pole forming an arch
until you are able to insert the pin into
pole end.

– Repeat for second pole.
– Attach tent frame clips to poles.

MONTANA

14’x7’

1

Layout & Positioning
of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1)

– Unzip door.
– Stake down tent corners, using the

tent stake loops. Keep the floor taut.
(illus. 2)

– Assemble all poles by interlocking

shock-corded poles.

– Insert the black poles into center pole

sleeves. The poles should cross
forming an “X” in the middle of tent.
(illus. 1)

2

When You Are Ready
To Set Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard or
sharp objects.

– Do not set up your tent under trees.
– For best results in windy conditions,

position the end of tent into the wind.

(2) Side Tent Poles

(Grey)

Rainfly Part No.

9279-349

(2) Main Tent Poles

(Black)

POLE ASSEMBLY PARTS

Front door

Instructions apply to Part Number 9279-147

illus. 1

illus. 2

Tent

stake through

stake loop

illus. 4

Center section upright

Part No. 9279-345

Part No. 9279-346

illus. 3

Pin & ring system located
on the front & rear of tent

Black poles

Black poles

(2) Rainfly Poles

Part No. 9279-348