Chauvet Work Light - Manual (Page 14)

Operation
-10- COLORado™ 2 Tour User Manual Rev. 02b
Continued from previous page
DMX Control With ID
Addressing
In this mode, the fixtures with the same DMX starting address will respond to the DMX
controller based on the fixture’s individual ID address setting. If the user selects ID
address “0”, all the fixtures with the same DMX address will respond in unison.
Otherwise, each fixture will follow the control for its particular ID address.
1) Repeat steps 1, 2, and 3 from DMX Control Without ID Addressing.
2) Activate ID Addressing in each fixture:
a) Press
b) Use or to select ID and press to accept.
c) Use or to select ON and press to accept.
d) Press
Static Color
The Static Color mode allows for permanent RGBW color mixing without a DMX
controller.
1) Press
2) Use or to select the desired color (Red, Green, Blue, or White).
3) Press to accept.
4) Use or to select the desired color value (0~255).
5) Press to accept.
6) Repeat for the other colors.
7) Use or to select Strob; press to accept.
8) Use or to select the desired frequency (0~20).
9) Press
Auto Programs
Auto programs allow for dynamic RGBW color mixing without a DMX controller. This
product has two types of Auto programs, preset (AT. 01~10) and custom (PR. 01~10).
1) Press
2) Use or to select the desired auto program (AT. 01~10 or PR.
01~10).
3) Press to accept.
You cannot edit preset Auto programs AT. 01~10. However, you can edit the
custom Auto programs PR. 01~10 (see Edit Customs).
Edit Customs
This setting allows the programming of up to 30 scenes for each of the 10 customizable
programs, including colors and effects.
1) Press
2) Use or to select the desired auto program (PR. 01~10).
3) Press to accept.
4) Use or to select the desired scene (SC. 01~30).
5) Press to accept.
6) Use or to select the desired color or effect (Red, Green, Blue,
White, Strobe, Time, or Fade).
7) Press to accept.
8) Repeat for the other colors or effects.
9) Press
10) Repeat for the other scenes.
11) Press
Continues on the next page