Casio EXILIM EX-Z1200 - Manual (Page 79)

79
SHOOTING A SNAPSHOT
■
Using Flash Assist
The subject in an image will look too dark if flash intensity is not
enough to reach a subject that is too far away. When this
happens, you can use flash assist to supplement the brightness
of the subject so it appears as if flash illumination was sufficient.
Flash assist is turned on as the initial factory default setting.
Use the following procedure to turn off flash assist when you do
not want to use it.
1. In a REC mode, press [MENU].
2. On the “Quality” tab, select “Flash Assist” and
then press [
X].
3. Use [
S] and [T] to select “Off” and then press
[SET].
When you want to use flash assist, select “Auto” here.
IMPORTANT!
• Flash assist may not produce the desired result for some
types of subjects.
• Any of the following can result in the flash assist effect
being canceled out.
– Changing the flash intensity (page 78)
– Correcting brightness (EV shift) (page 141)
– Changing ISO sensitivity (page 145)
– Changing the contrast setting (page 150)
Flash assist not used Flash assist used