Cadillac 2009 Escalade EXT - Manual (Page 176)

Disabling and Resetting IntelliBeam ® at
the Rearview Mirror
IntelliBeam ® can be disabled by using the controls on
the inside rearview mirror.
AUTO 3 (On/Off): To disable the system, press this
button on the inside rearview mirror. The IntelliBeam ®
indicator will turn off and will not come back on until the
IntelliBeam
® button is pressed again.
(Stalk Disable): When IntelliBeam ® has turned on the
high-beams, pull or push the high-beam stalk. This
will disable IntelliBeam
® . The IntelliBeam ® indicator on
the mirror will turn off. To re-enable IntelliBeam ® ,
press the IntelliBeam ® button on the mirror.
A different sensitivity setting is available for dealer
diagnostics. This is done by pushing and holding this
button for 20 seconds until the IntelliBeam
® indicator
light flashes three times. If you accidentally activate this,
the vehicle’s setting will automatically be reset each
time the ignition is turned off and then on again.
Cleaning the IntelliBeam ® Light Sensor
The light sensor is located
on the inside of the vehicle
in front of the inside
rearview mirror.
Clean the light sensor window, periodically, using glass
cleaner on a soft cloth. Gently wipe the sensor
window. Do not spray glass cleaner directly on the
surface of the sensor window.
Headlamps on Reminder
If a door is open, a reminder chime will sound when the
headlamps or parking lamps are manually turned on
and the key is out of the ignition. To turn off the chime,
turn the headlamp switch to off or AUTO and then
back on, or close and re-open the door. In the AUTO
mode, the headlamps turn off once the ignition is
in LOCK/OFF or may remain on until the headlamp
delay ends (if enabled in the DIC). See “Exit Lighting”
under DIC Vehicle Customization on page 3-56.
3-16