Casio XJ-350 - Manual (Page 46)

Projection Operations
46
To select the input source using remote controller keys
On the remote controller, press the [RGB/COMPONENT], [VIDEO], or [S-VIDEO] key to select
the input source you want.
z The currently selected input source name is shown in the upper right corner of the
projection screen.
z If the currently selected input source is not sending an input signal, the message “No
signal input” appears in place of the input source name.
z Whether the displayed input source name shows [RGB] or [Component] depends on the
current “Input Settings
J RGB Input” (page 85) setting that is configured on the
projector’s setup menu.
For information about configuring setup menu settings, see “Using the Setup Menu” on
page 61. For information about component video, see “Connecting to a Component Video
Output Device” on page 37.
If the input source name shows this: It means this input is selected:
RGB RGB
Component Component video