Baumer PA201 - Manual (Page 14)

PA201
14 www.baumer.com
2 Description
2.1 System description
The process display may be utilized as temperature indicator in
industrial environments.
-Thermocouple input J, K, T and Pt100
-Reading in °C (1/10 °C) or °F (1/10 °F)
-LED display, 4 digits and programmable
-DIN housing 48 x 24 mm
Display
4 digits
Sticker to indicate measuring unit
3 Connection
This chapter is about terminal assignment and will present some
wiring examples.
3.1 Terminal assignment
6XSSO\YROWDJH
3W&RPPRQ
3WWKHUPRFRXSOH
3WWKHUPRFRXSOH
$QDORJLQSXWV
Litz contact only by means of connector sleeves with insulating
enclosures for reasons of shock protection according to EN 61010.
Do not otherwise assign contacts that have been left unassigned ex
factory. We recommend to screen all sensor terminal leads and to
ground the shield on one side. Shields on both sides are recommen-
ded in case of RF interference or in case of equipotential bonding
over long distances. The sensor leads should not be in the same
phase winding as the mains supply and the output contact leads.