Cabletron Systems W85 - Manual (Page 40)

Chapter 4: Management
4-10 HSIM-W85 User’s Guide
ds1alarm
Syntax: ds1alarm
ds1alarm -[ea | da]
ds1alarm -[et | dt]
ds1alarm -sec
ds1alarm -sei
ds1alarm -sbr
ds1alarm -sbi
ds1alarm -mr
Description: The ds1alarm function allows the user to set error
thresholds in order to set traps and monitor the operation
and recovery of a device.
This option is either ALL to apply command
to all DS1 circuits, or the specific WAN physical identifier
associated with the DS1 circuit.
Options: ds1alarm (with no options) displays information on the
error thresholds.
-ea enables the WAN DS1 Alarms Admin.
-da disables the WAN DS1 Alarms Admin.
-et enables the WAN DS1 Alarms Traps Feature.
-dt disables the WAN DS1 Alarms Traps Feature.
-sec sets the Errored Seconds Threshold Count to
VALUE.
-sei sets the Errored Seconds Threshold Interval to
VALUE.
-sbr sets the Bipolar Violations Threshold Rate to
VALUE.
-sbi sets the Bipolar Violations Threshold Interval to
VALUE.
-mr manually recovers a DS1 link that has exceeded a
threshold