NISSAN 2011 GT R - Multi Function Display Owner's Manual User Manual
Page 64
Black plate (62,1)
Model "R35-N" EDITED: 2009/ 10/ 30
To set a previous start point as the destination:
“Previous Start Point” (Alternate Command
Mode)
SETTING FROM STORED ROUTES
It is possible to select a preferred route from the
stored routes.
1. Push
2. Highlight [Next Page] and push
3. Highlight [Stored Routes] and push TER>. A list screen is displayed. 4. Highlight the preferred route from the list and push 5. The entire route is shown on the map. Highlight [Start] after confirming the location INFO: . Even after setting a destination, the location of the destination can be adjusted, the “PROCEDURES AFTER SETTING DESTINATION” page 2-43 . The stored route includes only locations (destination and waypoints) and route cal- SETTING BY PHONE NUMBER If the phone number of a facility is known, it is INFO: . Telephone numbers that were stored for stored destinations can also be used. . If the area code of the specified telephone number does not exist in the map data, the . Only the locations included in the database in the map data can be searched by the 2-36 Navigation
destination is set.
of the displayed destination, and push
to the selected location and starts calculat-
ing a route.
location can be stored, etc.
culation conditions, not the route itself.
Therefore, when the destination is set using
a stored route, a different route may be
suggested if the current vehicle location is
different from the one when the route was
stored.
possible to search for a facility by entering the
phone number, and have the system calculate a
route.
system cannot search for the location.