beautypg.com

Controls and features – FORD 1999 Windstar User Manual

Page 82

background image

Programming

1. Prepare for programming the
HomeLink

௡ Universal Transceiver by

erasing the three factory default
codes by holding down the two
outside buttons until the red light
begins to flash after 20 seconds.
Release both buttons.

2. Hold the end of your hand-held
transmitter 5–14 cm (2–5 inches)
away from the HomeLink

௡ Universal

Transceiver surface (located on your visor) while keeping the red light in
view.

3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLink

௡ button. Do not release

the buttons until step 4 has been
completed.

4. The red light will flash slowly and
then rapidly. Release both buttons
when the red light flashes rapidly.

5. Follow steps 2 through 4 to program the remaining two buttons.

If you do not successfully program the HomeLink

௡ Universal Transceiver

after repeated attempts, refer to Rolling code programing which
follows, or call toll-free customer assistance: 1–800–355–3515 or on the
Internet at HomeLink.jci.com.

Canadian Programming

During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink

௡ Universal Transceiver.

Controls and features

82