FORD 1999 Windstar - Manual (Page 124)

Replacing the second row bench seat belt assemblies after a
collision
All second row bench seat belt assemblies adjacent to a sliding door have
special energy management retractors designed to further reduce the
risk of injury in the event of a head-on collision. These retractors should
be replaced if they were used in any accident in which the front airbags
deploy. If the safety belt assemblies are not replaced, there may be
increased risk of injury in the event of a subsequent collision.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
mi
FM1 ST ST AUTO P
1
2 3 4 5 6 7
RPMX1000 THEFT
TRAC ACTIVE TRAC OFF F FUEL
E
40
40
80 120
160 20
60 80
100
MPH
TEMP H
km/h
BRAKE
O/D
OFF O/D ON/OFF INFO
SETUP
RESET
DISC EJ
MUTE
VOL - PUSH ON OFF
T/C
FM1
REW FF
SCAN BASS TREB SEL BAL
TAPE EJ CD
FADE
AUTO
CLK
SIDE 1-2 COMP SHUFFLE
SEEK TUNE
AM FM
1 2 3 4 5 6
DOLBY B NR
A/C
FRONT
REAR
OFF
MAX
A/C
REAR
CONT
Seating and safety restraints
124