Erasing homelink buttons, Reprogramming a single homelink button, Driver controls – FORD 2011 Flex v.2 User Manual
Page 112
Erasing HomeLink
ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.
Reprogramming a single HomeLink
ா button
To program a device to HomeLink
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink
at www.homelink.com
or 1–800–355–3515.
Driver Controls
112
2011 Flex (471)
Owners Guide, 2nd Printing
USA (fus)