beautypg.com

Starting and stopping the engine 197 – FORD 2013 Flex v.1 User Manual

Page 197

background image

3. Press the start button. The engine may continue cranking for up to
10 seconds or until the vehicle starts.

To turn the ignition off, press the start button when the vehicle is on or
the engine is running.

The system will not function if:
• the key frequencies are jammed.
• the key battery is dead.
If you are unable to start your vehicle, do the following.

1. Insert the key into the key holder
located in the center console utility
compartment. Insert the key into the slot
with the buttons facing out and with key
ring up.

2. With the key in this position, you can
use the start button to switch the ignition
on and start your vehicle.

To stop the engine with the vehicle stationary, do the following:

1. Move the gearshift lever to P (Park).

2. Press the start button.

Note: The ignition, all electrical circuits, warning lamps and indicators
will be switched off.

To stop the engine when the vehicle is moving, do the following:

1. Press and hold the start button for at least one second or press the
start button three times within two seconds.

2. Shift to neutral and use the brakes to bring the vehicle to a safe stop.

3. After the vehicle has stopped, turn the engine off and shift into park.

WARNING: Switching off the engine when the vehicle is still
moving will result in a loss of brake and steering assistance. The

steering will not be locked, but higher effort will be required. When the
ignition is switched off, some electrical circuits, warning lamps and
indicators may also be off.

Starting and Stopping the Engine

197

2013 Flex (471)
Owners Guide gf, 1st Printing
USA
(fus)