beautypg.com

Universal garage door opener 185 – FORD 2013 Flex v.1 User Manual

Page 185

background image

1. Switch the ignition on.

2. Hold the garage door hand-held
transmitter 1–3 in. (2–8 cm) away
from the button you want to
program.

Note: During programming, the
hand-held transmitter may stop
transmitting. If this occurs press and

hold the function button while you press and release the hand-held
transmitter every two seconds. The indicator light will flash slowly and
then rapidly once the radio frequency signal is accepted.

3. Press and hold both buttons until the indicator light changes from
flashing slowly to rapidly, then release.

4. Press and hold the function button you programmed for 5 seconds,
then release. You may need to do this twice to activate the door. If your
garage door does not operate, observe the indicator light.

If the indicator light stays on, programming is complete. Press and
release the programmed button to activate the door.

If the indicator light flashes rapidly for two seconds than turns to a

constant light, follow the steps
below.

Note: You may need a ladder to
reach the unit and you may need to
remove the cover or lamp lens.

1. Press the learn button on the
garage door opener motor.

Note: You will have 30 seconds to complete the next step.

2. Return to your car.

3. Press and hold the function
button for 2 seconds, then release.
Repeat this step. Depending on the
brand of garage door opener you
may do repeat this sequence a third
time.

To program additional buttons repeat steps one through four.

For questions or comments, please contact HomeLink

௡ at

www.homelink.com or 1-800-355-3515.

Universal Garage Door Opener

185

2013 Flex (471)
Owners Guide gf, 1st Printing
USA
(fus)