beautypg.com

Replacing fog lamp bulbs, Replacing turn/backup lamp bulbs, Replacing tail/brake lamp bulbs – FORD 2013 Explorer v.4 User Manual

Page 361: 360 maintenance

background image

Replacing fog lamp bulbs

1. Make sure the headlamp switch is off.

1. Make sure that the fog lamp switch
is in the off position.

2. Remove the bulb socket from the
fog lamp by turning it
counterclockwise.

3. Disconnect the electrical
connector.

Reverse steps to reinstall bulb(s).

Replacing turn/backup lamp bulbs

The turn/backup lamp bulbs are located in the same area of the tail lamp
assembly, one below the other. Follow the same steps to replace these
bulbs:

1. Make sure the headlamp switch is in the off
position, then open the liftgate to expose the lamp
assembly bolts.

2. Remove the two bolt covers using a standard flattip
screwdriver.

3. Remove the two bolts from the lamp assembly.

4. Carefully remove the lamp assembly away from the
vehicle by pulling the assembly straight out to expose
the bulb socket.

5. Remove the bulb socket from the
lamp assembly by turning it
counterclockwise.

6. Pull bulb straight out of socket.

7. Install the new bulb in reverse
order.

Carefully install the tail lamp
assembly on the vehicle by securing
the lamp assembly with two bolts.
Reinstall bolt covers.

Replacing tail/brake lamp bulbs

For bulb replacement, see your authorized dealer.

360

Maintenance

2013 Explorer (exp)
Owners Guide gf, 4th Printing, November 2012
USA
(fus)