FORD 2013 Explorer v.4 - Manual (Page 176)

MEMORY FUNCTION (IF EQUIPPED)
This memory control, located on
the driver’s door, allows automatic
positioning of the driver seat,
power mirrors, steering column
(if equipped) and power adjustable
foot pedals (if equipped) to three
programmable positions.
Programming a memory position
Note: You can program a memory position at any time.
• To program position 1, move the memory features to the desired
positions using the associated controls. Press and hold button 1 for at
least two seconds. A chime will sound confirming that a memory
position has been set.
• To program position 2 and 3, repeat the previous procedure using the
respective buttons.
Recalling a memory position
You can recall a programmed memory position:
• in any gearshift position if the ignition is not on.
• only in position P or N if the ignition is on.
Press the desired memory control to recall a memory position.
Recalling memory positions with the remote control
You can recall memory positions when you press unlock on your remote
control (if the transmitter is programmed to a memory position) or,
when you enter a valid personal entry code that is programmed to a
memory position. If the easy entry feature is enabled, the seat will first
move to the easy entry position. The seat will move to the final position
when the key is in the ignition or when the push button start system
(if equipped) is put in accessory mode or started.
To program the memory feature to a remote control, see the Keys and
Remote Control chapter.
Seats 175
2013 Explorer (exp)
Owners Guide gf, 4th Printing, November 2012
USA (fus)