beautypg.com

Replacing headlamps (sealed beam), Maintenance 231 – FORD 2013 E-450 v.2 User Manual

Page 232

background image

2. Remove the three screws from
the headlamp assembly and pull the
assembly straight out.

3. Disconnect the electrical
connector by squeezing the release
tab and pushing the connector
forward, then pulling it rearward.

4. Remove the bulb assembly by
turning it counterclockwise and
pulling it straight out.

To install the new bulb, follow the removal procedures in reverse order.

Replacing Headlamps (Sealed Beam)

1. Make sure the headlamp switch is in the off position, then open the
hood.

2. Remove the four screws from the
headlamp assembly and carefully
remove the lamp/bezel.

3. Remove the four screws and the
retaining ring.

4. Disconnect the electrical
connector from the lamp and
remove the lamp.

To install the new lamp, follow the
removal procedures in reverse order.

Maintenance

231

2013 Econoline (eco)
Owners Guide gf, 2nd Printing, November 2012
USA
(fus)

This manual is related to the following products: