beautypg.com

Replacing components – BMW 325xi Sports Wagon 2006 User Manual

Page 122

background image

Replacing components

120

any instructions provided by the bulb manufac-
turer.

<

For care and maintenance of the headlamps,
please follow the instructions in the separate
Caring for your vehicle brochure.

If the routine for changing a particular
bulb is not described here, please contact

your BMW Center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel.

<

Light-emitting diodes LEDs

Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.

Do not remove the covers or expose the
eyes directly to the unfiltered light source

for several hours at a time, otherwise this could
cause irritation to the retina.

<

Xenon lamps

*

The service life of these bulbs is very long and
the probability of a failure is very low, provided
that they are not switched on and off an unusual
number of times. If a xenon lamp fails neverthe-
less, switch on the fog lamps and continue the
journey with great care, provided that local leg-
islation does not prohibit this.

Have work on the xenon lighting system
performed only by your BMW Center or a

workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel. Due to the high electrical voltages
present, there is a risk of potentially fatal acci-
dents if work is performed inappropriate.

<

Parking lamps, roadside parking lamps

In the event of a malfunction, please contact
your BMW Center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel.

Halogen lamps

H7 bulb, 55 watts

Always wear gloves and eye protection;
the atmosphere within the H7 bulb is

pressurized. Otherwise there is a risk of injury if
the bulb is damaged.

<

There are separate headlamp covers for low-
beam headlamps and high-beam headlamps.

Be careful when installing the covers, oth-
erwise leaks could occur and cause dam-

age to the headlamp system.

<

For checking and adjusting headlamp
aim, please contact your BMW Center.

<

Access to the lamps

The high-beam headlamp can be accessed
from the engine compartment, whereas the
low-beam headlamp is accessed through a flap
in the wheel well.

1 Cover for high-beam headlamp
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:

1.

Fold the respective wire bracket to the side,
see arrows.

2.

Flip open the cover and take it out of the
guide.

Follow the same steps in reverse order to reat-
tach the covers.

Access through the wheel well

Only for low-beam headlamps and turn signals:

Online Edition for Part-No. 01 41 0 012 353 - © 03/06 BMW AG