beautypg.com

Coolant, Brake system – BMW 325xi Sports Wagon 2006 User Manual

Page 117

background image

Refere

nce

At a gl

anc

e

Controls

Dr

iv

ing

tip

s

Mobi

li

ty

115

If BMW High Performance Synthetic Oil is not
available, you can add small quantities of other
synthetic oils in between oil changes. Only use
oils with the API SH specification or higher.

Your BMW Center will be glad to answer
any questions regarding BMW High Per-

formance Synthetic Oil or approved synthetic
oils.

<

You can also call BMW of North America at
1-800-831-1117 or visit the website
www.bmwusa.com to obtain this information.

Viscosity ratings

Viscosity is a measure of an oil's flow rating and
is categorized in SAE classes.
Selecting the appropriate SAE class depends
on the regional climatic conditions in which you
normally drive your BMW.

Approved oils belong to the 5W-40 and
5W-30 classes.

<

These oils can be used for driving at all outside
temperatures.

Coolant

Do not add coolant to the cooling system
when the engine is hot. Escaping coolant

can cause burns.

<

Coolant is a mixture of water and an additive.
Not all commercially available additives are suit-
able for your BMW. Ask your BMW Center for
suitable additives.

Only use suitable additives, otherwise
engine damage may result. The additives

are hazardous to your health.

<

Comply with the appropriate environ-
mental protection regulations when dis-

posing of coolant additives.

<

Checking coolant level

1.

The engine must be at ambient tempera-
ture.

2.

Turn the cap of the expansion tank a little
counterclockwise to allow any accumulated

pressure to escape, then continue turning
to open.

3.

The coolant level is correct if it is between
the maximum and minimum marks in the
filler neck, refer also to the diagram next to
the filler neck.

4.

If the coolant is low, slowly add coolant up to
the specified level; do not overfill.

5.

Turn the cap until there is an audible click.

6.

Have the reason for the coolant loss elimi-
nated as soon as possible.

Brake system

Malfunctions

Brake fluid

The warning lamps light up in red
even though the handbrake has been
released. Stop immediately.

The brake fluid in the reservoir has fallen to
below the minimum level. At the same time, a
considerably longer brake pedal travel may be
noticeable. Have the system checked without
delay.

Display of this malfunction on Cana-
dian models.

If you continue to drive the car, you may
have to depress the brake more and brak-

ing distances may be significantly longer.
Please adapt your driving style accordingly.

<

Online Edition for Part-No. 01 41 0 012 353 - © 03/06 BMW AG