Brake force display – BMW M5 Sedan 2007 User Manual

Page 87

works according to BMW repair procedures
with correspondingly trained personnel.

Malfunction

The yellow warning lamp flashes and
then lights up continuously. The tires
are shown in gray on the Control Dis-

play and a message is displayed. No flat tire can
be detected.
A message like this is displayed in the following
situations:

In case of a malfunction;
have the system checked.

If a wheel is mounted without TPM elec-
tronics

If TPM is temporarily interfered with by
other systems or devices which use the
same radio frequency.

Declaration according to NHTSA/

FMVSS 138 Tire Pressure Monitoring
Systems

Each tire, including the spare

, should be

checked monthly when cold and inflated to the
inflation pressure recommended by the vehicle
manufacturer on the vehicle placard or tire infla-
tion pressure label. If your vehicle has tires of a
different size than the size indicated on the
vehicle placard or tire inflation pressure label,
you should determine the proper tire inflation
pressure for those tires. As an added safety fea-
ture, your vehicle has been equipped with a tire
pressure monitoring system, TPMS, that illumi-
nates a low tire pressure telltale when one or
more of your tires are significantly under-
inflated. Accordingly, when the low tire pres-
sure telltale illuminates, you should stop and
check your tires as soon as possible, and inflate
them to the proper pressure. Driving on a signif-
icantly under-inflated tire causes the tire to
overheat and can lead to tire failure. Under-
inflation also reduces fuel efficiency and tire
tread life, and may affect the vehicle's handling
and stopping ability. Please note that the TPMS
is not a substitute for proper tire maintenance,
and it is the driver's responsibility to maintain
correct tire pressure, even if under-inflation has

not reached the level to trigger illumination of
the TPMS low tire pressure telltale.
The TPMS malfunction indicator is combined
with the low tire pressure telltale. When the sys-
tem detects a malfunction, the telltale will flash
for approximately one minute and then remain
continuously illuminated. This sequence will
continue upon subsequent vehicle startups as
long as the malfunction exists. When the mal-
function indicator lights up, the system may not
be able to detect or signal low tire pressure as
intended. TPMS malfunctions may occur for a
variety of reasons, including the installation of
replacement or alternate tires or wheels on the
vehicle that prevent the TPMS from functioning
properly. Always check the TPMS malfunction
telltale after replacing one or more tires or
wheels on your vehicle to ensure that the
replacement or alternate tires and wheels allow
the TPMS to continue to function properly.

Brake force display

On the left: normal braking.
On the right: heavy braking.

ba8_m5us.book Seite 85 Montag, 5. Februar 2007 12:03 12