Turn signals/headlamp flasher/high beams, Gnals, Driving – BMW X5 3.0si SAV 2007 User Manual
Page 64
Driving
62
3.
Insert the releasing tool, contained in the
onboard tool kit under the floor panel, refer
to page
, into the opening, arrow
1.
4.
Turn the releasing tool as far as possible,
arrow
2, and then press downward. The
transmission lock is released.
Lock the transmission lock after parking
the vehicle at its destination. Otherwise
there is a danger of the vehicle rolling.
<
Locking
1.
Pull out the releasing tool.
The transmission lock is locked again.
2.
Close the cover in the bottom of the cup
holder and lay in the mat again.
3.
Close the cover of the cup holder and stow
the releasing tool.
The display in the instrument cluster
must change from N to P after locking the
transmission lock. Otherwise there is a danger
of the vehicle rolling.
<
Information on jump starting and towing from
page
.
Turn signals/headlamp
flasher/high beams
1 High beams
2 Headlamp flasher
3 Turn signals
Using turn signals
Press the lever beyond the resistance point.
To switch off manually, press the lever up to the
resistance point.
Atypically rapid flashing of the indicator
lamp indicates that a turn signal bulb
needs to be replaced.
<
Signaling briefly
Press lever to resistance point and hold for as
long as you wish to signal.
Triple turn signal activation
Press the lever up to the resistance point; the
turn signal flashes once.
You can switch over this function so that the
turn signal flashes three times. The setting is
stored for the remote control currently in use.
iDrive, for explanation of concept, refer to
page
.
1.
Press the
button.
This opens the start menu.
2.
Press the controller to open the menu.
3.
Select "Settings" and press the controller.
4.
Select "Vehicle / Tires" and press the con-
troller.
Online Edition for Part no. 01 41 0 012 501 - © 08/06 BMW AG