BMW X5 3.0si SAV 2007 User Manual

Page 226

Under t

224

Change to upper field if necessary. Turn the
controller until "Service requirements" is
selected and press the controller.

Change to the second field from the top if
necessary. Turn the controller until "Engine
oil level" is selected and press the control-
ler. The oil level is displayed.

Possible messages

"Engine oil level O.K."

"No measurement available: Updating
engine oil level measurement...":
Engine oil level is being measured. This
process can take approx. 3 minutes when
stopped on a level surface and approx.
5 minutes while driving.

"Oil level at the minimum! Refill with 1 quart
of engine oil.":
Add 1 US quart/liter of engine oil at the next
opportunity.

"Engine oil level too high":

Have the vehicle checked immedi-
ately, otherwise engine damage may

result if too much oil has been added.

"Please observe recalculated service inter-
val for engine oil":
Do not add engine oil. Continued driving is
possible. To do this, observe the recalcu-
lated remaining mileage until the next oil
change service, refer to page

226

. Have the

system checked as soon as possible.

Adding engine oil

Do not add 1 US quart/1 liter of oil until a corre-
sponding message is shown on the Control Dis-
play.

Add oil within the next 125 miles/200 km,
otherwise the engine could be dam-

aged.

Continuous exposure to used oil has
caused cancer in laboratory testing.

For this reason, any skin areas that come into
contact with oil should be thoroughly washed
with soap and water.
Keep oil, grease etc. out of reach of children and
observe the warnings on the containers to pre-
vent health risks.

Oil change

Only have an oil change carried out by a BMW
Sports Activity Vehicle Center or a workshop
that works in accordance with BMW guidelines
and uses appropriately trained personnel.

Approved engine oils

The quality of the engine oil selected has critical
significance for the operation and service life of
an engine. BMW continuously approves spe-
cific oils after confirming their suitability for use
in its vehicles with extensive testing.

Do not use oil additives, as these may
result in engine damage.

Only use approved BMW High Performance
Synthetic Oil.
If BMW High Performance Synthetic Oil is
unavailable, you can add small quantities of
other synthetic oils between oil changes. Only
use oils of the specification API SH or higher.

This manual is related to the following products:

2007 X5 3.0SI