beautypg.com

Replacing components, Onboard tool kit, Wiper blades – BMW Z4 sDrive35i 2009 User Manual

Page 210: Lamps and bulbs, Press the red

background image

Replacing components

208

Replacing components

Onboard tool kit

The onboard tool kit is located in the cargo bay
under the floor panel.

Wiper blades

1.

Fold up the wiper arm.

2.

Fold the wiper blade upwards.

3.

Press the hook.

4.

Pull the wiper blade downward out of the
holder and remove it toward the top left, see
arrow.

To avoid damage, make sure that the
wiper arms are resting against the wind-

shield before you open the engine compart-
ment.

<

Lamps and bulbs

Lamps and bulbs make an essential contribu-
tion to vehicle safety. They should, therefore,
be handled carefully. BMW recommends hav-

ing your BMW center perform any work that you
do not feel competent to perform yourself or
that is not described here.

Never touch the glass of new bulbs with
your bare fingers, as even minute

amounts of contamination will burn into the
bulb's surface and reduce its service life. Use a
clean tissue, cloth or something similar, or hold
the bulb by its base.

<

You can obtain a selection of replacement bulbs
at your BMW center.

Only change bulbs while they are cool to
the touch, otherwise you could suffer

burns.

<

When working on electrical systems,
always begin by switching off the con-

sumer in question, otherwise short-circuits
could result. To avoid possible injury or equip-
ment damage when replacing bulbs, observe
any instructions provided by the bulb manufac-
turer.

<

For care of the headlamps, please follow the
instructions in the chapter entitled 'Care'.

If the routine for changing a particular
bulb is not described here, please contact

your BMW center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel.

<

Light-emitting diodes LED

Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.

Do not remove the covers or expose the
eyes directly to the unfiltered light source

for several hours, otherwise this could cause
irritation to the retina.

<

Online Edition for Part no. 01 41 2 602 116 - © 01/09 BMW AG

This manual is related to the following products: