BMW 550i xDrive Sedan 2011 User Manual
Page 273
▷
Maneuvering capability is limited during cor‐
nering.
▷
The tow bar will generate lateral forces if it
is secured with an offset.
Tow rope
When starting to tow the vehicle, make sure that
the tow rope is taut.
To avoid jerking and the associated stresses on
the vehicle components when towing, always
use nylon ropes or nylon straps.
Attaching the tow rope correctly
Only secure the tow rope on the tow fit‐
ting; otherwise, damage can occur when it is se‐
cured on other parts of the vehicle.◀
Tow fitting
The screw-in tow fitting should always be car‐
ried in the vehicle. It can be screwed in at the
front or rear of the BMW. It is located in the con‐
tainer on the inside of the trunk lid.
Tow fitting, information on use
▷
Use only the tow fitting provided with
the vehicle and screw it all the way in.
▷
Use the tow fitting for towing on paved roads
only.
▷
Avoid lateral loading of the tow fitting, e.g.,
do not lift the vehicle by the tow fitting.
Otherwise, damage to the tow fitting and the ve‐
hicle can occur.◀
Screw thread
Push out the cover by pressing on the top edge.
Tow-starting
Automatic transmission*
Do not tow-start the vehicle.
Due to the automatic transmission, the engine
cannot be started by tow-starting.
Have the cause of the starting difficulties rem‐
edied.
Manual transmission
If possible, do not tow-start the vehicle but start
the engine by jump-starting, refer to page
.
If the vehicle is equipped with a catalytic con‐
verter, only tow-start while the engine is cold.
1.
Switch on the hazard warning system and
comply with local regulations.
2.
3.
Engage third gear.
4.
Have the vehicle tow-started with the clutch
pressed and slowly release the clutch. After
the engine starts, immediately press on the
clutch again.
5.
Stop at a suitable location, remove the tow
bar or rope, and switch off the hazard warn‐
ing system.
6.
Have the vehicle checked.
Seite 273
273
Online Edition for Part no. 01 40 2 606 469 - 03 11 490