Telephone – BMW 760Li Sedan 2012 User Manual
Page 214
If the pairing was successful, the mobile phone
appears at the top of the list of mobile phones.
The functions supported by the mobile phone
and audio device are displayed as symbols when
paired.
White symbol: the function is active.
Gray symbol: the function is inactive.
Symbol
Function
Telephone.
Additional telephone.
Audio source.
Four devices can be paired with the vehicle at
once. Three devices can be connected with the
vehicle at once.
If pairing was unsuccessful: What to do if..., refer
to page
Following the initial pairing
▷
The mobile phone is detected/connected in
the vehicle within a short period of time
when the engine is running or the ignition is
switched on.
▷
The phone book entries of the telephone
stored on the SIM card* or mobile phone are
transmitted to the vehicle after detection,
depending on the mobile phone.
▷
Four devices can be paired.
▷
Specific settings may be necessary in some
mobile phones, e.g., authorization or a se‐
cure connection; refer to the mobile phone
operating instructions.
Connecting a specific device
If more than one device is detected by the vehi‐
cle, the device at the top of the list is connected.
A different device can be connected by select‐
ing it.
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
Select the device that is to be connected.
The functions that were assigned to the device
before unpairing are assigned to the device
when it is reconnected. If the device is already
connected, these functions are deactivated.
Configuring the devices
Additional functions can be activated or deacti‐
vated for paired and connected devices.
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
Highlight the device to be configured.
4.
Open "Options".
5.
"Configure phone"
6.
At least one function must be selected.
▷
"Telephone"
▷
"Additional telephone"
▷
"Audio"
7.
"OK"
If a function is assigned to a device, the function
will be deactivated where appropriate for a de‐
vice that is already connected and the device will
be unpaired.
Swapping the telephone and additional
telephone
The function of the telephone and additional tel‐
ephone can be swapped automatically.
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
"Swap phone/addit. phone"
Unpairing a device
1.
"Telephone"
2.
"Bluetooth® (phone)"
3.
Highlight the device that is to be unpaired.
4.
Open "Options".
5.
"Remove phone from list"
What to do if...
Information on suitable mobile phones, refer to
page
Seite 214
214
Online Edition for Part no. 01 40 2 606 497 - 03 11 490
Telephone